+86 13251303762
info@best-filtration.com
MBR Membrane
Reverse Osmosis Membrane
Residential Ro Membrane
UF Membrane
Water Treatment Plant
Residential Ro Machine
Brackish Ro System
Sea water system/SW RO plant
Membrane Cleaning System(CIP)
Consumables Accessories
Product introduction:
BMUF100-1860/1880 The membrane module is installed with hollow membrane filament with inner diameter of 0.7mm and outer diameter of 1.3mm. The filtration method is internal pressure, i.e., the raw water is driven by the pressure difference and enters into the inner part of the hollow filament, and permeates through the hollow filament along the radial direction from the inside to the outside. Thus, it can filter It can remove all kinds of bacteria, colloid, suspended solids, microorganisms and other harmful substances in the raw water.
Application:
- Mineral water, mountain spring water and other sterile liquid preparation;
- Drinking treatment of tap water surface water, well water and river water;
- Pre-treatment of RO reverse osmosis device;
- Industrial wastewater treatment, recycling and utilization.
Product detailed parameters：
| Product Description | MODEL | BMUF100-1860 | BMUF100-1880 |
| Membrane area（㎡/ft²） | 51/549 | 77/829 | |
| MWCO | 100000 DAL | 100000 DAL | |
| Membrane material | Reinforced PVDF | Reinforced PVDF | |
| Membrane Pore Size(μm) | 0.03 | 0.03 | |
| Fiber dia.ID/OD(mm) | 0.7/1.3 | 0.7/1.3 | |
| Structure | Out-side in | Out-side in | |
| L(mm/inch) | 1,860/73.2 | 2,360/92.9 | |
| L1(mm/inch) | 1,500/59.1 | 2,000/78.7 | |
| L2(mm/inch) | 1,630/64.2 | 2,130/83.9 | |
| L3(mm/inch) | 1,820/71.7 | 2,320/91.3 | |
| D(mm/inch) | 225/8.9 | 225/8.9 | |
| W1/W2(mm/inch) | 180(7.1)/342(13.5) | 180(7.1)/342(13.5) | |
| Connector size | DN50 | DN50 | |
| Pressure Vessel/Fitting Material | UPVC/SS304 | UPVC/SS304 | |
| Potting Material | Food grade expoxy resin | Food grade expoxy resin | |
| Application data | Operating Mode | Dead-End Filtration or Crossflow | Dead-End Filtration or Crossflow |
| Normal working pressure | ≤0.3MPa | ≤0.3MPa | |
| Typical Filtrate Flux Range | 15000L/H(0.15Mpa,25℃) | ||
| Design Flux(L/㎡.h) | 50-100(0.1Mpa, 25℃) | 50-100(0.1Mpa, 25℃) | |
| Maximum Transmembrane Pressure(Mpa) | ＜0.2 | ＜0.2 | |
| Maximum Operating Temperature(℃) | 40 | 40 | |
| PH Range | 2-10 | 2-10 | |
| Feed requirement | Feed Turbidity | ≤70NTU | ≤70NTU |
| Oil | ≤2mg/L | ≤2mg/L | |
| Feed SS | ＜100mg/L | ＜100mg/L |
Spanish 
English 
Russian